STATUS INSTRUMENTS / TEMPERATURE TRANSMITTERS

TTR200 & TTR200X

RTD TEMPERATURE TRANSMITTER

MULTI TYPE RTD, SLIDE WIRE, RESISTANCE INPUTS
ATEX, UKEX AND IEC Ex APPROVED VERSION
SENSOR OFFSET or OUTPUT ALIGNMENT
ADJUSTABLE INPUT FILTER
PROGRAMABLE BURNOUT

ขอใบเสนอราคา↗ โทรหาเรา 081-454-5784

ราคาและระยะเวลานำเข้าขึ้นกับรุ่นและจำนวน ทีมงานตอบกลับภายใน 1 วันทำการ

เอกสารดาวน์โหลด

DatasheetPDF · 315 KB↓คู่มือการใช้งานPDF · 499 KB↓EC DeclarationPDF · 157 KB↓

01 / OVERVIEW

ภาพรวม

The TTR200 ‘smart’ transmitter is designed for use with RTD or slidewire sensors. The flexible design allows the use of any resistive sensor within the range of (10 to 10500) Ω. Pt100, 500, 1000, Ni or Cu sensors as well as slide wire sensors up to 100 KΩ can be accommodated. Other sensor characteristics or your own 22-point linearization characteristics (for slidewire or linear resistance) can be downloaded into the product enabling you to adapt it exactly to your application. The TTR220X is approved to UKEX, ATEX and IEC Ex standards allowing for use in hazardous area applications.

PC configuration allows the user to select Sensor type, Range, Filter, Tag, Units and error signal without requiring calibration equipment. Additionally, the user may read live process data when connected to the PC, this allows for sensor offset, and output alignment calibration, where the user can enter values to match the actual process and therefore reduce system errors.

02 / FEATURES

คุณสมบัติเด่น

Sensor Referencing (Temperature mode)

The TTR200 sensor referencing via the Windows based USBSpeedlink software allows for close matching to a known reference sensor eliminating possible sensor errors.

Custom Linearisation

As standard the TTR200 has all common RTD sensors available from its software library. Additionally, the TTR200 can be programmed with up to 22-point custom linearization for ohms and slidewire inputs.

Sensor Burn Out Detection (Temperature mode)

If a sensor wire is broken or becomes disconnected the TTR200 output will automatically go to its user defined level (upscale or downscale) or a pre-set value.